3D工口里番全彩无码,91精品福利观看,3D工口里番全彩无码

產品資料
1 GHz 有源差分探頭
產品型號:AP034
產品廠商:
簡介:

美國力科 lecory 1 GHz 有源差分探頭 1 GHz 有源差分探頭AP034


? 1 GHz Bandwidth
? x1 Gain
? ÷10 and ÷20 External Attenuators
? 10,000: 1 DC CMRR
? Low 35 nV/÷Hz Noise
? 1.5 pF/Side Input C
? 2 mV/div - 2 V/div
? Input Protection

Autobalance Feature

The AP034 is a high-performance active differential probe. High bandwidth, excellent common-mode rejection ratio, (CMRR) and low noise make the AP034 ideal for applications such as disk drive design and failure analysis, as well as wireless and data communication design.

Fully Integrated: With the ProBus® interface, the AP034 probe becomes an integral part of the oscilloscope. The probe sensitivity and offset can be controlled from the oscilloscope front panel, the probe front panel, or by using remote control commands (GPIB or RS-232).

Sensitivity, offset, input capacitance, and common-mode voltage range are displayed on the oscilloscope screen. When used with a LeCroy digital oscilloscope, no external power supply is required.

Wide Dynamic Range: The AP034 probe provides a range of sensitivities from x1 gain to ÷10 and ÷20 attenuation (with plug-on attenuators) for diverse signals. The sensitivity can be adjusted continuously from 2 mV/div to 2 V/div (2 V/div is achieved with plug-on attenuator) when used with a LeCroy oscilloscope.

DC CMRR is greater than 10,000:1 (80 dB).

OFFSET up/down buttons allow OFFSET control from the probe amplifier body. Momentarily holding down both buttons will zero the OFFSET.

A supplied AC coupling capacitor head (0.1 mF) allows operation with large common- mode or differential DC inputs.

Autobalance
Holding both offset buttons down for two seconds with the input connections removed invokes Autobalance. This provides the highest accuracy on all ranges by removing residual DC offset from the probe.

Low Noise
At full gain, the noise is less than 35 nV/÷Hz, allowing direct measurement of low-amplitude and high-bandwidth signals.

Input Characteristics
The input capacitance is modeled by 1.5 pF to ground from each input, plus 0.10 pF from input to input. This is equivalent to 0.9 pF differential input capacitance. Input resistance is 1 MOhm, including the accessory plug-on attenuator head. An AC coupling plug-on accessory features a 0.1 mF coupling capacitor for each input. Low-frequency CMRR is reduced when using this accessory.

Use with other Instruments

Instruments with 50 Ohm inputs, such as spectrum and network analyzers, time interval analyzers, and others, pose a challenge when the signal to be measured is differential or high-impedance. Low noise, high-bandwidth, and clean phase response make the AP034 probe an ideal signal conditioner to solve these problems. The optional ADPPS Power Supply provides power to the AP034 and converts the output to a conventional male BNC connector.

 

 產品實圖
相關產品
    <noscript id="l83dq"><i id="l83dq"></i></noscript>
    <var id="l83dq"><i id="l83dq"></i></var>

    主站蜘蛛池模板: 龙江县| 安义县| 大埔区| 静海县| 大埔区| 林周县| 江孜县| 绩溪县| 南昌市| 四川省| 尉氏县| 依兰县| 新野县| 旬邑县| 大埔区| 邯郸市| 阳泉市| 巴东县| 汨罗市| 京山县| 始兴县| 炎陵县| 资溪县| 尚志市| 佛教| 理塘县| 社旗县| 遵化市| 同心县| 洪湖市| 游戏| 松溪县| 中山市| 曲靖市| 中卫市| 屏边| 宣城市| 上饶市| 连城县| 万安县| 五大连池市|